0.1mm 3D printer release film without glue

0.1mm 3D printer release film without glue

Our 3D printer membrane is our newest products for 3D printer releasing specially .It is used for 3D printers which (UV curing,SLA and DLP type).It is placed in a tray for the glue to release, instead of silicone film

Main features:

1. high transmittance, UV light through rate of 92%, the curing time is shorter, better curing effect, higher precision printing;

2. More durable, release more than thirty thousands times. (refer to the printed page);

3. For many types of UV light curing 3D printer.

Note: If you need any products of ours, please kindly contact with us directly by following contaction . Then we can reply you faster and easy . Thanks

Type A: Peel off the protective film ,and then paste the release film onto the tank.Take the place of silicon film. More conveniently to use than silicon film ,much longer working life than silicon film ,just like to pasted Mobile screen protective film .

Type B :without adhesive ,but it need to be fixed at the bottom of the tray .

Size: 210 * 290 mm, and about the same size A4 paper, special sizes (20 or more) contact the owner customization.

Thickness: Type A: Thickness 0.125 mm; Type B: Thickness 0.1 mm.

Note: There is a mark to mention its the

Note:

Type A has adhesive and has positive and negative side.After peeling off the protective film ,paste the release film to the tank directly .The one without adhesive is protective film ,peel it off and away,use the one with adhesive (adhesive side face to tank to paste)

Type B has no adhesive ,fixed the film by user ,its both sides can be used freely.

HOW TO USE IT ?

Cutting :

Please choose a clean ,windless,dustfree room to operate. Washing hands clean, using art knife to cut the film into the right size you need .Edge must be orderly. Size can be a little smaller than the glue tank’s bottom plane.

Clean:

Clean the glue tank with microfiber cleaning cloth which is sent with the goods (or other glasses cloth),no Dust or blot,or it will comes our bubble after pasting.

Paste:

Tear up the protective film from the 3D printer film at one corner and then paste it like pasting a phone’s protecting film .